Can a magnetometer detect cracks in an oil well?
Hello,
I came across a webpage of your information while researching about fluxgate magnetometers. I am hoping you may be able to provide some insight into this project.
I am involved in the oil and gas industry in Western Canada particularly in the fracture stimulation of oil and gas wells. I am looking for an alternate method to detect the induced fractures in the formation. As a background if you are not familiar with the technique, high pressure pumpers pump a slurry down the wellbore through holes in the steel casing over the zone of interest. They pump at high enough pressures to fracture the rock and fill the fractures (1 to 10mm wide) with the sand laden slurry. We currently add a radioactive tracer to this slurry and run in the wellbore after the fracture treatment is done to "see" where the fracture has gone. Typically these fractures can extent 1 to 500 meters away from the wellbore and grow vertically 1 to 100 meters in height. The current method of fracture detection only identifies the radioactive material up to 20 inches away from the wellbore. It would be advantageous to be able to map the direction, length and width of the fractures for their full length.
Based on this limited explanation do you see potential for some type of magnetometer to be useful in this application. Keep in mind there is steel casing in the wellbore. As well we could add magnetic particles to the slurry which could in effect make the fracture a magnetic conduit?
REPLY
2 February 2006
I tried hard to figure out a way magnetometers could help you, but could not find any. Even with highly magnetized material, the field gets rapidly weaker with distance, and quickly gets undetectable..
If the slurry were highly conducting electrically, you could perhaps put a high voltage pulse on the pipe and see how "echoes" of the pulse is received at various locations on the ground--a bit like an EKG. However... high voltage electricity near oil and gas is not a good idea, and electrical properties of the slurry are probably not much different from those of the surrounding rock.
I believe that magnetometers were used for a long time in prospecting for gas an oil in Canada, and one of the pioneers was Lawrence Morley, who made a great name in science: he was the first to suggest that the magnetic stripes on ocean-floor rock came from gradual spreading of such rocks, which led to the current view of plate tectonics. I wrote about that in
http://www.phy6.org/earthmag/reversal.htm
and in more detail in
http://www.phy6.org/earthmag/mill_6.htm
The journals refused to publish Morley's article, considering it too far out. A little while later Vine and Matthews arrived at the same conclusion, had it published, and for a long time they alone were given credit, before the world learned about Larry Morley.
I hope he is still with us today: we met once and I found him charming. More about him at
http://www.ryerson.ca/~oars/morely.htm (that's the spelling there!)
also at
http://www.science.ca/scientists/scientistprofile.php?pID=201
February 19th is his birthday--go ahead, raise a toast to him on that day!